How to turn on the smart watch?
1.Register a guardian bai account
1) After the card is turned on, download an APP software;
2) Open the bai software, enter the login interface, click "register" directly, and then enter the information according to the prompts to complete the registration.
2. Set the family number
1) After completing the above registration, you can enter the account password to log in;
2) After the login is successful, you can set several groups of family numbers in the device, set the most frequently used number as the first one, and cycle the calls in sequence when the device calls.
3. Set the call mode
1) Single call and two-way call are optional. Single call means that the phone can hear the sound of the watch, but the single watch cannot hear the voice of the phone. Two-way conversation can be understood as a normal call mode;
2) Special note: This device is a compulsory call, no matter it is in one-way or two-way mode, the mobile phone dials the watch directly, the watch cannot refuse or does not need any operation, the watch calls the mobile phone and it rings normally, according to the set family number The call will be dialed sequentially, once you press and hold the call button, the watch will not be able to hang up. After 2 cycles, the phone will not hang up until the phone is answered.
4. Set the working mode
1) Emergency mode: The device uploads positioning data once in 10 seconds, which can grasp the dynamics of the device in time, but the power consumption is large, the working time is greatly reduced, and the standby time is about 8 hours. Please use this mode with caution;
2) Power saving mode: upload the positioning data every 10 minutes, and use this mode normally. It is recommended that customers use this mode, and the use time is 24-30 hours:
3) Sleep mode: Upload positioning data once an hour. This mode can be used to save power consumption when the device is stationary for a long time. The use time is 30-50 hours; the above use time is the test time, and the specific duration is due to the signal at the time of the device The intensity is related, there will be slight discrepancies.